I also blocked off the air holes on the other side, and ran some wicking over to the other side.
Hits really nice at only 34 watts. The resistance is about .67.
![[IMG]](https://lh3.googleusercontent.com/blogger_img_proxy/AEn0k_v3PQxXCN5HUzYhjhPAMjBXu1YhQmBhqtPCNzHOEr5_OOplvsrkXvKMwOh0mbzsueuS2tDDy6dj=s0-d)
Sent from my R1 HD using Tapatalk
from General Vaping Discussion http://ift.tt/2yxWNhj
Sunday, 12 November 2017
General Vaping Discussion
It's 5 wraps plus 5 wraps of 24awg with an ID of 3.5 mm. On this RBA, there are two air holes on the bottom of the deck. So I centered each half of the coil over each air hole.
I also blocked off the air holes on the other side, and ran some wicking over to the other side.
Hits really nice at only 34 watts. The resistance is about .67.
Sent from my R1 HD using Tapatalk
from General Vaping Discussion http://ift.tt/2yxWNhj
I also blocked off the air holes on the other side, and ran some wicking over to the other side.
Hits really nice at only 34 watts. The resistance is about .67.
Sent from my R1 HD using Tapatalk
from General Vaping Discussion http://ift.tt/2yxWNhj
Subscribe to:
Post Comments (Atom)
-
Hello, can someone send me a good ss316l profile for DNA 75c? I remember djlbs vapes has it on website, but I can't find it.. from G...
-
You dripped a carto You dripped a Cisco You've used a Boge You've squonked with a carto on your Reo Grand You've gone to the...
No comments:
Post a Comment